15-03-2023, 11:37 AM
(15-03-2023, 09:42 AM)sgbuffett Wrote: You can use a resistor or use pencil to draw on the spoilt led position.
The higher voltage is distributed so should not be that bad...the higher voltage compensate for the missing led in terms of brightness.
Do not advise pple to do the same as shown in yr YouTube. Their voltage is 110 v. ours is 220 volt. Depending on yr luck and circuit design , quite likely u will get a shock when touching the metal part. Do it without power
aiptasia is now in my ignored list.
Omi.. Thank you for bumping up the message.